Skip to content

V01 Mounting Bracket for the Vecoven PWM Mod

The V01 mounting bracket for the Vecoven PWM mod, allows the two boards of the mod to be mounted off the voice-boards in a MKS-70.

The V01 custom mounting bracket for Vecoven PWM mod for MKS-70
Custom mounting bracket for Vecoven PWM kit in Roland MKS-70.

Occupying the space previously taken up by the transformer, the V01 can ONLY be fitted if Guy Wilkinson's P0004 power supply is installed.

V01 bracket fitted in Roland MKS-70
Notice that Guy Wilkinson's P0004 power supply is also fitted.

There are two main advantages to using the V01 mounting bracket for the Vecoven PWM mod:

  • You don't have to drill any holes into your MKS-70 voice-boards.
  • The PWM mod can very easily and quickly be disconnected from the voice-boards.

IMPORTANT: The V01 mounting bracket is a great solution and keeps things tidy but... due to the fact that the V01 mounts the Vecoven PWM boards in very close  proximity to the voice-boards, it's strongly recommended that vertical IDC headers are fitted to the PWM boards and that the Molex headers used on the ribbon cables are NOT foldback types.

Read more about upgrades for the Roland Super-JX here, or check out Fred Vecoven's awesome PWM mod here. Alternatively, you can just buy it now:

A full guide to mounting the Vecoven PWM daughter-boards to the V01 bracket and securing the V01 bracket into your MKS-70, is available after purchase.